The Sobbat DB-2 is an analog overdrive pedal made by Sobbat. It is the lower-gain sibling of the DB-1 within Sobbat's drive line, and Sobbat describes its character as "Fine sustain as DB-1. Less gain and a little rougher than DB-1. sound like big tube old amp sound, even at low level."1 For a player, that places it in the territory of a cranked old tube amp rather than a high-gain distortion, and it sits among the broader family of overdrive pedals on this site.
What it does
The DB-2 is a straightforward overdrive: it pushes the front end of an amp with a moderate amount of gain while keeping sustain, in the way Sobbat describes for the DB-1 but with less gain on tap and a rougher edge. The maker's own description of sounding like a "big tube old amp" even at low level points to a pedal intended to work at modest volumes, where many drives only come alive when the amp is loud.1
It is an analog circuit, which matters to players who keep their boards analog or who stack drives and want to know what is in the signal path.1
The DB-2 draws 13mA at 9V DC, center negative. That is a light load for a modern supply, so it can share a daisy-chained output with other low-draw pedals without trouble.1
Where it sits among other drives
With less gain than the DB-1 and a rougher voicing, the DB-2 is closer to a low-to-mid gain overdrive than a distortion. Players looking for more clipping or a harder edge would compare it against distortion pedals or fuzz pedals, while those after a clean volume lift would look at boost pedals instead. For a closer look at how two well-known drives differ in gain and voicing, see the Boss SD-1 vs Ibanez TS9 Tube Screamer comparison1.
Videos
sobbatpedal
sobbatpedal
sobbatpedal
Questions
Is the Sobbat DB-2 analog or digital?
The DB-2 is an analog circuit, according to Sobbat's product listing on RockBoard's PedalPedia. That matters for players who build their board around analog signal paths or who want to keep digital converters out of their chain. It is an overdrive, so it sits alongside the other gain pedals on the site's overdrive type page rather than with distortion or fuzz units.
How is the Sobbat DB-2 powered?
The DB-2 runs on 9V DC with center negative polarity and draws 13mA, per Sobbat's product listing. That is a modest draw by modern standards, so it fits comfortably on a daisy chain or a small isolated supply alongside other compact pedals. The listing does not give a battery option, so a regulated 9V supply is the way to run it.
Sources (1)
- DB-2 by Sobbat, RockBoard PedalPedia, 2026