tonebx
☰
BrandsPlayersGuidesNewsAll pedal typesComparisons

Pedals › MIDI › Pedalnetics

Pedalnetics Helauxy Duo
Photo: Reverb

Pedalnetics Helauxy Duo

MIDI
Key facts
TypeMIDI controller with two footswitches1
MakerPedalnetics2
FootswitchesTwo, FS1 and FS2, each with its own LED1
MIDI channelConfigurable from 1 to 161
Default modePreset down/up (Red/Blue)1

The Pedalnetics Helauxy Duo is a MIDI controller with two footswitches, FS1 and FS2, each with its own LED1. Pedalnetics builds it as an auxiliary switch for MIDI-equipped gear, and it sits among the maker's small controllers alongside the Auxidi Duo and the Auxidi Solo Mini Angled. A second version, the Helauxy Duo Midi v2, was released on August 10, 20242.

Modes and MIDI channel

The controller defaults to preset down/up mode, shown as Red/Blue on the LEDs1. The MIDI channel is configurable from 1 to 16. In MIDI channel edit mode, the left footswitch decrements the channel by one, and if you decrement beyond channel 1 it wraps back around to 16; incrementing beyond channel 16 wraps back around to 11.

Double-press and factory settings

Double-press mode is enabled at the factory and set to Tuner, so a double press calls up the tuner function on the connected device1. The full factory settings are:

  • MIDI Channel 1
  • Preset Down/Preset Up Mode
  • Double-press mode enabled, set to Tuner
  • Left footswitch FS1, right footswitch FS21

Saving settings and firmware

Settings save automatically: wait 10 seconds with no button presses and the controller saves your settings and reboots itself. Unplugging the device will prevent the save1.

Leave the Helauxy Duo powered for 10 seconds after any change. Unplugging before the save completes means the change is lost1.

On startup the LEDs report the firmware version: a Red Red Red flash sequence indicates Firmware Version 1.01. The maker's manual also describes a startup LED test, in which both switch LEDs run a quick Red Green Blue test, first the FS1 LED, then the FS2 LED1.

Videos

3 Cheap Upgrades That Bring the HX Stomp Into 2026
MrDees

Questions

How do I save settings on the Helauxy Duo?

Settings save automatically. After making a change, wait 10 seconds with no button presses and the controller saves your settings and reboots itself. Unplugging the device before that 10 seconds is up will prevent the save, so leave it powered until it reboots.

What are the factory settings of the Helauxy Duo?

Out of the box the Helauxy Duo is set to MIDI channel 1, in Preset Down/Preset Up mode, with double-press mode enabled and set to Tuner. The left footswitch is FS1 and the right footswitch is FS2.

Sources (2)
  1. Helauxy Duo MIDI Config, Pedalnetics, 2023-10-08
  2. Helauxy Duo Midi V2 Release, Pedalnetics, 2024-08-10

Other midi pedals

All midi pedals