The Joyo JF-04 High Gain Distortion is a distortion pedal from Joyo. Joyo pitches it plainly: "Get the kind of hard distortion used by the bands you love--from the crunch of AC/DC to the heavy metal of Metallica."1 It is a four-knob pedal with controls for Gain, Treble, Mid and Volume, plus true bypass.1
What the High Gain Distortion does
The JF-04 is a high gain distortion pedal: it clips the guitar signal hard to produce saturated, aggressive distortion rather than the softer breakup of an overdrive. Joyo says that "with a full range of EQ adjustment and tone control, you'll be able to get whatever sound you are after."1
The four controls cover the essentials:
| Control | What it does |
|---|---|
| Gain | Sets the amount of distortion, from light crunch to full saturation |
| Treble | Shapes the high end |
| Mid | Cuts or boosts the midrange, including scooped settings |
| Volume | Sets the output level into the amp |
Guitar Chalk's Bobby Kittleberger notes the pedal is true bypass, so it leaves your clean signal alone when switched off.2
Where it belongs in your signal chain
Guitar Chalk gives clear placement advice for the JF-042:
- It works well before the amp's input; avoid using it in the effects loop.
- It is best suited for solid-state or clean tube amp channels.
- Place it after your tuner and before modulation effects to minimize pedal chain noise.
- Keep the gain between 12 and 2 o'clock for tight, articulate distortion.
On practical use, Guitar Chalk judges it sufficient for practice, recording, and small to mid-size gigs.2
If you run a tube amp, set the channel clean and let the pedal do the distorting. Guitar Chalk found the JF-04 best suited for solid-state or clean tube amp channels, not an already-crunching channel.2
Sample settings from blues to doom
Guitar Chalk published a set of recommended presets for the JF-04 running from low-gain blues to scooped thrash and doom.2
| Preset | Gain | Treble | Mid | Volume | Character |
|---|---|---|---|---|---|
| Bluesy Crunch | 3 | 5 | 6 | 6 | Warm, touch-sensitive blues tone |
| Classic Rock Drive | 5.5 | 6 | 7 | Thick, punchy classic rock | |
| High Gain Metal | 9 | 7 | 4 | 7 | Aggressive, saturated metal distortion |
| Scooped Thrash | 8.5 | 8 | 2 | Extreme mid-scoop thrash tone | |
| Doom/Stoner Sludge | 10 | 4 | 8.5 | 6.5 | Doom and stoner sludge tones |
The spread shows what the four-knob layout buys you: the same pedal covers a warm blues crunch at Gain 3 and a fully saturated doom sludge at Gain 10, with the Mid control doing much of the work between a scooped thrash cut (Mid 2) and a thick stoner midrange (Mid 8.5).2
For comparison, other high-gain distortions take different routes to the same territory. Pedal of the Day's reviewer found that on the Humanoid FX Apparition High Gain Turbo Distortion, "The lowest gain setting will give tight Blues and Classic or hard rock tones," with max gain approaching full fuzz and a scooped midrange.3 The DSM & Humboldt Black Clouds High-Gain Distortion takes a more configurable approach, with three modes of operation that, in Pedal of the Day's words, "can adapt to virtually any setup," and a reviewer who found "there's such a wide range here" of settings and tonal options.4 The JF-04's answer is simpler: one circuit, four knobs, and a wide range of EQ settings.
Joyo makes several other distortion pedals alongside the JF-04, including the Joyo Crunch Distortion, the JOYO US Dream, the Joyo R-17 Dark Flame and the Joyo JF-21 Splinter.
Videos
JOYO Direct
Dennis Kayzer
Cryptic Mask Guitar
Questions
Is the Joyo JF-04 true bypass?
Yes. The JF-04 High Gain Distortion uses true bypass switching, so with the pedal off your guitar signal passes through without coloring the tone. That makes it a safe fit on a larger pedalboard where you want the bypassed signal to stay clean.
What power supply does the Joyo JF-04 use?
Use a 9V DC center-negative power supply for optimal performance. That is the same standard polarity and voltage as most modern distortion pedals, so a typical pedalboard power supply with 9V center-negative outputs will run it without any special adapter.
Can I put the Joyo High Gain Distortion in my amp's effects loop?
No. Guitar Chalk advises that the pedal works well before the amp's input and that you should avoid using it in the effects loop. Distortion pedals are designed to hit the amp's front end, and the loop's line-level signal is the wrong match for this circuit.
Does the Joyo High Gain Distortion work with a tube amp?
It is best suited for solid-state amps or clean tube amp channels. Running it into an already-distorting tube channel stacks gain in a way that can get muddy, so if you use a tube amp, set the channel clean and let the pedal create the distortion.
Sources (4)
- JF-04 HIGH GAIN DISTORTION _JOYO, JOYO
- JOYO High Gain Distortion Pedal Settings, Guitar Chalk, 2025-06-09
- Humanoid FX Apparition High Gain Turbo Distortion, Pedal of the Day, 2024-10-12
- DSM & Humboldt Black Clouds High-Gain Distortion, Pedal of the Day, 2023-03-19









